







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tuff Shed Driveway & Pavers: The Denton Owner’s Guide
We install Tuff Shed-compatible driveway and paver work in Denton, and a typical installed paver driveway runs $7,000 – $18,000 depending on square footage, base prep, and border detail. Concrete driveways land at $4,500 – $12,000, and sealing an existing drive costs $250 – $700. Bradford Remodeling Co Denton is an independent service provider and is not affiliated with Tuff Shed.

Owners usually call us after a wet spring, not a dry summer. The shed slab settles a half inch, the pavers along the apron heave, and water starts running back toward the structure instead of away from it. In Denton, that pattern shows up fast on the clay soils north of the Square and out toward Argyle, where the ground swells when it rains and shrinks hard in August. By the time you see a crack at the threshold, the base under it has already moved.
Key Takeaways
- Installed paver driveways in Denton run $7,000 – $18,000; concrete runs $4,500 – $12,000.
- The failure is almost always in the base, not the paver or slab surface.
- Blackland clay movement is the number one cause of heaving and settling here.
- Every project gets a written price before work starts and the 365-Day Done Right Promise.
Which Tuff Shed Models This Applies To

Tuff Shed builds in several lines, from the basic garden-style units up through the Premier and Tahoe series, and the driveway and paver work we do sits around whatever footprint the shed uses. The shed itself isn’t the variable; the apron, the approach, and the drainage grade around it are. A 10×12 garden shed in a Denton backyard needs a different apron than a 12×24 Premier sitting at the end of a gravel drive.
Before we quote, we measure three things: the width of the door opening, the finished height of the shed floor above grade, and the slope from the street or alley to the shed threshold. Those numbers decide whether you need a poured concrete apron, a paver apron, or a full paver driveway extension. If the shed floor sits more than 6 inches above the surrounding grade, you’ll want a ramp or step-and-landing detail worked into the paver plan, and that’s a spec we confirm on site rather than guess at.
On the OEM-vs-aftermarket question: Tuff Shed sells some site and foundation accessories, but the driveway and paver work around a shed is not a Tuff Shed part in the OEM sense. It’s hardscape. That means the material decision is yours, and we install Belgard and Unilock pavers with manufacturer specs and warranties that back our own 365-Day Done Right Promise. If you’ve priced a Belgard or Unilock paver against a big-box concrete paver, you already know the difference in the joint and the face.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tuff Shed Driveway & Pavers Is Failing
These are the symptoms we see most often on Denton properties. Each one points to a cause, and the cause is what we fix.
- Pavers rocking underfoot at the apron. The sand bedding has washed out or the base wasn’t compacted in lifts. Walking it back into place doesn’t fix it; the base has to come up.
- A crack running from the shed threshold toward the street. That’s a slab or apron crack caused by differential settlement, usually clay shrinking under one edge. A crack that widens season to season means the subgrade is moving.
- Water pooling against the shed wall after rain. The grade has fallen toward the structure instead of away from it. This is the one that damages the shed floor and the framing above it, not just the pavers.
- Weeds pushing up through the joints. The polymeric sand has failed or was never installed correctly. In Denton’s heat, a cheap joint sand gives out in two or three summers.
- Sunken or heaved borders. Edge restraint has pulled loose, letting the field spread. Once the border moves, every paver behind it loses its lock.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work actually costs in Denton, and what’s inside each number.
| Scope | Installed Price Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
What drives the range: square footage first, then base depth, then edge restraint and drainage correction. A driveway that needs 6 inches of compacted base and a new French drain at the low corner prices higher than a flat reseat over a sound base. We give you a written price before any work starts, itemized so you can see base prep, pavers, edge, joint sand, and haul-off as separate lines. No number moves at the door. Every completed job carries the 365-Day Done Right Promise: if the pavers settle, the joints fail, or the grade doesn’t drain the way we said it would within a full year, we come back and correct it at no charge.
DIY or Call Us?
There’s real work you can safely do yourself here, and there’s work that will cost you more if you try.
You can rake leaves and debris off the apron, pull weeds from the joints, and eyeball the grade with a level to see which way water runs. You can also photograph cracks with a tape measure alongside them so you can tell whether they’re growing between seasons.
What goes wrong on a DIY paver job is the base. Homeowners rent a plate compactor, dig 3 inches, and lay pavers over soil that hasn’t been compacted in lifts. Two wet seasons later the drive is rocking and the shed apron has dropped. Cutting and fitting edge restraint, setting the drain slope away from the structure, and getting the joint sand packed correctly are the three steps that separate a paver drive that lasts twenty years from one that’s done in three. We’d rather you call us at (844) 651-3175 for a free estimate than spend a weekend and a rental fee on a base that won’t hold.
FAQs

A properly installed paver driveway over a compacted base lasts 25 to 30 years in Denton’s climate. The pavers themselves outlast the base in most cases, which is why base prep is where the money belongs. Call (844) 651-3175 for an exact quote on your drive.
Often yes, if the failure is isolated to one section and the surrounding base is sound. A localized reseat of the apron or a section of the field costs a fraction of a full replacement. We’ll tell you straight which one you need after we’ve looked at the base, not before.
A standard two-car paver driveway in Denton takes three to five working days, including demo, base prep, and joint sand. A short apron or patio runs one to two days. Weather and access to the site are the two variables that move that schedule.
We specify from a documented roster of name-brand hardscape lines, Belgard and Unilock among them, so the material has a manufacturer spec sheet and warranty behind it. That traceability matters when a joint or face fails and you need a replacement run matched to the original. Call (844) 651-3175 and we’ll walk you through the options for your shed footprint, your grade, and your budget.
We also install KraftMaid, Cambria, and Silestone products on interior projects if your remodel work runs inside the house. Every Denton project starts with a written price, a background-checked and uniformed crew, and a live person on the phone 24/7, not a voicemail. Call (844) 651-3175 for a free estimate, and we’ll leave you with a clean site, a signed written guarantee, and a driveway squared away.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












