







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
James Hardie Driveway & Pavers: The Denton Owner’s Guide
James Hardie-compatible driveway and paver work in Denton runs $7,000 – $18,000 installed for a paver driveway, with surface prep, base correction and finish included in the written price. We install James Hardie exterior systems alongside Belgard and Unilock hardscape, and we handle the whole scope from tear-out to the final sweep. Most Denton owners find out something has failed the same way: a loose edge paver rocks underfoot, a hairline crack opens along the drive after a freeze, or water starts pooling against the garage slab after a hard rain.

Key takeaways:
- Installed paver driveway in Denton: $7,000 – $18,000. Sealing alone: $250 – $700.
- Most failures trace to base, drainage or edge restraint, not the surface material.
- Every price is written before work starts and covered by the 365-Day Done Right Promise.
Which James Hardie Models This Applies To

James Hardie is best known in Denton for siding, trim and soffit, and that matters here: the driveway and paver scope usually sits at the junction where Hardie exterior products meet the hardscape. When a homeowner tells us “the James Hardie part failed,” it’s almost always one of three things – a Hardie trim or fascia board at the garage header that’s holding water, a Hardie panel edge within 6 inches of grade, or the paver apron and edge restraint where the drive meets the Hardie-clad wall.
Identifying the right component starts with the label. Hardie siding and trim carry a mill stamp on the back face with the product line (HardiePlank, HardiePanel, HardieTrim) and dimensions. HardiePlank lap siding comes in 5-1/4″, 6-1/4″, 7-1/4″ and 8-1/4″ exposures; measure the exposed face, not the total board width, or you’ll order the wrong profile and it won’t line up with the courses above and below. Trim boards run 3/4″ and 1-1/4″ thickness most commonly on Denton homes. Bring a photo of the stamp and a tape measurement and the match is straightforward.
On OEM versus aftermarket: for Hardie trim and siding, the OEM part is the safe call. Hardie’s fiber cement formulation is engineered to a specific density and moisture performance, and the warranty attaches to the genuine product. For the paver and base components underneath, quality aftermarket equivalents from Belgard or Unilock are a legitimate choice and often a better value – these are documented, spec’d products with their own manufacturer warranties. We won’t spec a no-name paver to save a dollar, and we’ll tell you when the OEM part is the only one worth buying.
Bradford Remodeling Co Denton is an independent remodeling contractor. We’re not affiliated with James Hardie, and we don’t claim to be.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your James Hardie Driveway & Pavers Is Failing
Denton sits on expansive clay soil, and that’s the single biggest driver of driveway and paver failure in this market. Clay swells when it’s wet and shrinks hard in a dry summer. The movement doesn’t stop at the slab edge – it works on the base under your pavers and on any Hardie trim that’s too close to grade.
- Pavers rocking or settling unevenly. The base wasn’t compacted in lifts, or the clay beneath it has moved. A rocking paver is the first sign; if it’s ignored through a wet spring, the joint sand washes out and the whole field shifts.
- Joint sand washing out after rain. Usually a drainage problem, not a sand problem. Water is running toward the drive instead of away, and re-sanding without fixing the grade just buys you a few months.
- Edge restraint pulling loose. The most common failure we see on Denton drives. Without a properly pinned edge, the pavers spread outward and the drive loses its line within a season or two.
- Hairline cracks opening along the Hardie trim at the garage header. That’s a moisture path. Hardie trim shouldn’t sit closer than 2 inches to a hardscape surface, and the caulk joint needs to be a real backer-rod joint, not a smear.
- Efflorescence – a white chalky bloom on the pavers. Mineral salts drawn to the surface by moisture. It can be cleaned, but recurring bloom usually means water is getting under the pavers and staying there.
In Denton, we regularly see edge and base failures on drives installed during the dry season without a moisture check on the subgrade. The pavers looked perfect at handoff and started moving the first wet fall.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here are the Denton price ranges we work to. Every number is the installed price, parts plus labor, written before work begins:

| Scope | Installed price range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement (full tear-out) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
What moves the number: the square footage, how much base has to come out and be recompacted, whether the subgrade needs lime stabilization for the clay, edge restraint material, and whether we’re resetting the Hardie trim at the garage header. A drive that only needs the failed edge rebuilt and re-sanded lands near the low end. A full tear-out over bad base lands at the top.
Included in every written price: demolition and haul-off, base preparation and compaction, edge restraint, joint sand, and site cleanup. No change orders at the door. The finished work carries the 365-Day Done Right Promise. If the pavers settle, the edge lets go, or the Hardie trim joint fails inside that full year, we come back and correct it at no charge.
DIY or Call Us?
There’s a safe middle ground. You can walk the drive and mark the rocking pavers, photograph the Hardie mill stamp, and check whether water pools against the garage after a rain. That diagnostic work saves time on the estimate and costs nothing.
Where DIY goes wrong: resetting pavers without addressing the base is a temporary fix, and it usually makes the next failure worse because the joint sand is disturbed twice. Edge restraint has to be properly pinned into stable subgrade, and clay soil in Denton will reject a shallow spike. And any work that involves opening up or resetting the Hardie trim at the garage header is a moisture and water-management job – get it wrong and you’re dealing with rot and a much bigger repair. That’s the point where a trained crew is the cheaper call.
Call (844) 651-3175 for a free estimate. A live person answers, 24 hours a day, seven days a week. Background-checked, uniformed technicians do the work, and every price is in writing before a tool comes out.
FAQs

How long does a paver driveway last in Denton?
A properly installed paver driveway over stable, compacted base should hold 20 to 30 years in this climate. The clay soil is what actually determines lifespan – a drive that was compacted in lifts and pinned at the edge will outlast one installed on a shallow sand bed by a wide margin. Call (844) 651-3175 to get an honest read on your existing drive.
Can it be repaired instead of replaced?
Often, yes. If the base is sound and the problem is a localized edge failure, a handful of rocking pavers, or washed-out joint sand, a targeted repair runs far less than a full replacement. We don’t quote a replacement if a repair will actually hold. Call (844) 651-3175 for an assessment.
How long does the swap take?
A localized paver and edge repair is typically a one-day job. A full paver driveway installation in Denton generally takes three to five working days, depending on square footage and how much base has to be rebuilt. The schedule is written into the estimate so you know what you’re committing to.
How do you source the James Hardie component?
We source genuine Hardie trim and siding through suppliers who carry the stamped product line, matched to your mill stamp and measurements – never a generic fiber cement substitute. Paver and base materials come from documented manufacturers including Belgard and Unilock, and we also work with KraftMaid, Cambria and Silestone on interior scopes. Every product we specify has a manufacturer warranty behind it and is listed in your written estimate before work starts.
If a James Hardie trim joint, paver apron, or full driveway in Denton has started to fail, the fix starts with a written price and a crew that stands behind it for a full year. Bradford Remodeling Co Denton is part of the Garrison Partners family and held to The Garrison Standard – written price before work, background-checked crews, and the 365-Day Done Right Promise on every completed job. Call (844) 651-3175 to schedule your free estimate.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












