







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Driveway & Pavers: The Denton Owner’s Guide
If your Wellborn driveway or paver system has a failed section, we install Wellborn-compatible hardscape to match the original profile, and in the Denton market that runs $7,000 – $18,000 for a full paver driveway, with repair sections priced to the actual affected area. We are an independent contractor and are not affiliated with Wellborn; we work with the brand’s documented specifications the same way we work with Belgard and other hardscape lines. Most Denton owners don’t find the failure by walking the driveway on a nice day. They find it after a spring storm pushes water against the garage slab, or after a wheel drops half an inch in the same spot three mornings in a row on the way out to Loop 288.

Key takeaways before you read on:
- We install and repair Wellborn-compatible hardscape but do not stock parts or carry materials on a truck.
- Full paver driveway work in Denton: $7,000 – $18,000. Repair sections scale down from there.
- Every project gets a written price before work starts and the 365-Day Done Right Promise.
- A live person answers (844) 651-3175, 24/7, and estimates are free.
Which Wellborn Models This Applies To

Wellborn paver systems show up across a handful of profile families, and getting the match right is the whole job. The profile is the shape of the paver’s edge, and profile families dictate both the joint geometry and how the unit interlocks under load. If a Denton driveway was laid with a specific Wellborn series and you replace two courses with a lookalike from a big-box pallet, the replacement units will sit proud or create a lateral slip line within a season.
Here is how we identify what you actually have:
- Measure a single unit. Length, width, and nominal thickness. Thickness is the one that matters most; a 2 3/8 inch unit and a 2 3/4 inch unit do not substitute cleanly in a driveway that takes vehicle load.
- Look for a manufacturer stamp on the face or the side channel of an existing paver. Wellborn units are typically stamped; installers sometimes flip them face-up without a visible mark, so pull one from a corner or edge course.
- Note the color and finish family. Color runs drift between production lots, so a 2026 match to a 2016 install needs a dye-lot or blend conversation, not a swatch comparison in the garage light.
On the OEM-versus-aftermarket decision: OEM Wellborn paver units give you a traceable profile and a spec sheet our installers can work against. A quality aftermarket paver in the same nominal dimensions can work fine on a patch repair in a low-traffic area, and we’ll tell you honestly when it will. On a driveway that takes two vehicles a day plus a North Texas August, profile and thickness match is not negotiable, and that usually points back to OEM or a documented equivalent.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Driveway & Pavers Is Failing
Paver failures in Denton almost always trace to water, base, or both. The paver is rarely the weak link. Here is what we see, and what it actually means:
- Sunken or rocking units in a wheel path. The base layer underneath has lost density or the bedding sand has migrated, usually because water is getting in through a failed joint or a bad edge restraint and pumping the fines out from below.
- Weeds and sand loss in the joints. Joint sand is what locks the system together; when it washes out, the pavers lose their interlock and start to shuffle against each other. In Denton, our spring downpours and heavy clay subgrade drive this harder than most markets.
- Heaving or a ridge across the driveway. That is expansion pressure, often from a tree root zone or from a base that was never compacted in lifts. It won’t fix itself, and it will crack units if you drive over it long enough.
- Standing water against the garage slab or along the low edge. A drainage or slope failure, and the most expensive one to ignore. Water against a Denton slab works under the plate and into the framing over repeat seasons; pavers holding water in the wrong place are a foundation problem waiting to happen.
- Broken or chipped units in one localized area. Point load damage, or a unit that was never fully seated on the bedding layer. Sometimes it’s a single paver; sometimes it’s the visible tip of a base failure that runs three feet back.
Replacement Cost & What’s Included
Paver driveway installation in Denton runs $7,000 – $18,000. What moves you up or down that range:
- Square footage and access. A two-car driveway with a straight shot from the street is the low end. Tight lots, gates, and any hand-carrying push the number up because labor drives the range.
- Base prep. If the existing base is sound, you’re paying for the top. If it has to be excavated and rebuilt in compacted lifts, that’s the largest single line item.
- Edge restraint and drainage. Proper edge restraint is what keeps a Denton driveway from spreading at the sides over the first three summers. If a downspout or grading change is needed, we price it in writing before we start.
- Paver selection itself. Premium units and imported color runs cost more.
Our part on this is straightforward: you get a written price before any work begins, itemized so you can see materials and labor, and that number does not move at the door. Every completed hardscape project carries the 365-Day Done Right Promise. If a joint fails, a section settles, or the work doesn’t hold inside that year, we come back and correct it at no charge. That is the guarantee in writing, and you should hold every contractor to it.

See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this is safe to check yourself. Measure your paver footprint, pull a loose unit from a corner to look for the stamp and the thickness, and note where water pools after a rain. That’s information we need anyway, and you can gather it on a Saturday. If a single loose paver in a low-traffic spot needs re-bedding, that’s a fair weekend job for a careful homeowner with the right sand and a rubber mallet.
Where DIY goes wrong on a driveway is the base and the load path. Pavers on a driveway take the weight of vehicles, and a base that isn’t excavated to the right depth, compacted in proper lifts, and restrained at the edge will settle within a season. Tear out and re-bed a whole section without that discipline and you’ll be back where you started. That’s the honest split. When the failure is broader than one paver, call us. Our technicians have up to 22 years of experience on hardscape and remodeling work, and they’re background-checked and uniformed, so you know who’s walking your property.
One local note worth a phone call: if the paver issues are part of a wider project, say a garage conversion or a front walkway tied to a porch rebuild, we work with Belgard hardscape alongside the rest of our scope. We also install KraftMaid, Cambria, and Silestone on the interior end of a project.
FAQs

How long does a Wellborn paver driveway last in Denton?
A properly installed Wellborn paver driveway with a compacted base and good edge restraint should hold 25 to 30 years of Denton driving, though our heavy clay soil and spring rain mean joint sand needs replenishing every few years to keep the system locked. If the base was never built right, expect failure in the first three to five years, which is when most Denton calls come in.
Can my Wellborn driveway be repaired instead of replaced?
Yes. If the failure is a section rather than the whole drive, we can pull, re-base, and reset matching units, and that’s often the right call and the cheaper one. It depends on whether the base under the failed area is the problem or just the surface. We’ll tell you which you’re looking at in writing before any work starts. Call (844) 651-3175 for a free estimate.
How long does the swap take?
A full paver driveway in Denton typically takes two to four working days depending on square footage and whether the base is being rebuilt; a sectional repair is usually a one-day job. We confirm the schedule in the written scope so you know when the crew will be there and how long the driveway will be out of service. Call (844) 651-3175 and we’ll get you on the schedule.
How do you source the part?
We source Wellborn-compatible pavers through documented material channels so the profile, dimensions, and color family match the original specification, not a guessed substitute. We don’t stock parts and we don’t carry materials on a truck, so we confirm the source and lead time before the job is scheduled. That traceability is part of The Garrison Standard: specs and price in writing before any work starts. Call (844) 651-3175 for a free estimate.
Squared Up, Not Patched
A failing driveway in Denton doesn’t need a sales pitch. It needs a straight number, a documented scope, and a crew that shows up when it says it will. That’s what The Garrison Standard means at Bradford: written price first, background-checked and uniformed technicians on every job, live-person phone coverage around the clock, and a signed 365-Day Done Right Promise in your hand when the job closes. When a project is done right, the site is clean, the scope is documented, and the guarantee paperwork is already signed. No surprises, no change orders at the door.
Call (844) 651-3175 for a free estimate. A real person answers, day or night, and we’ll tell you exactly what your driveway needs and what it costs before anything gets touched.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












