







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Kitchen Remodeling in Denton, TX: The Denton Owner’s Guide
We install IKO-specified kitchen remodeling for Denton homeowners, and the installed price typically lands between $14,000 and $45,000 depending on cabinetry, countertop square footage, and whether the rough-in moves. IKO is known in North Texas mainly through its roofing and waterproofing line, so when a Denton homeowner tells us “the IKO part failed,” we start by nailing down exactly what’s on the label before we quote anything. Most people discover the problem the same way: a soft spot at a sink base, a seam on the underlayment lifting, or a flashing detail at a window that started letting water in behind the backsplash. We verify the product, match the spec, and put the fix in writing before a tool comes out.

Which IKO Models This Applies To

IKO’s catalog is deep, and the part number matters more than the brand name on the box. On the waterproofing and membrane side, homeowners most often run into IKO Gold, IKO Shield, and the Armourglass and Cambridge shingle lines when a roofer or a previous remodel touched their kitchen. For a kitchen, the relevant IKO products are the underlayments, waterproofing membranes, and any roof flashing detail above a kitchen bump-out or dormer. To identify the right part, look for the printed label on the roll or bundle, the square-foot coverage number, and the lot code. Measure the width of the roll in inches before you order – a 36-inch membrane and a 39-inch membrane are not interchangeable on a narrow galley layout, and that measurement is where most Denton orders go wrong.
On the OEM-versus-aftermarket question: for IKO membranes, a quality aftermarket equivalent from a name-brand manufacturer will meet or exceed the same ASTM spec and is usually fine. For anything carrying a manufacturer warranty tied to the IKO system, use the IKO part so the warranty stays intact. We work with a documented roster of name-brand materials, including KraftMaid, Cambria, and Silestone alongside the IKO-specified membrane and flashing, so every line on your spec sheet is traceable. Bradford Remodeling Co Denton is an independent remodeling contractor and is not affiliated with IKO.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Kitchen Remodeling Is Failing
The failure almost never announces itself. Denton’s climate does the announcing for you – a wet spring followed by a 100-degree July works a membrane and a flashing detail harder than most of the country. Here’s what we see:
- Soft or spongy floor at the sink base. Water has gotten past the membrane or a supply line and is sitting in the substrate under the cabinet. By the time the floor feels soft, the damage is usually six months old.
- Lifted or curled membrane seams. The adhesive has let go, often from heat cycling in an unconditioned wall cavity. Once a seam lifts, water wicks underneath instead of running off.
- Water staining on the ceiling below a kitchen bump-out. A flashing detail at the wall-to-roof transition has failed, and the IKO membrane under the flashing is no longer shedding water.
- Musty smell that doesn’t clear after cleaning. Moisture is trapped behind a cabinet back or under the underlayment. A dehumidifier won’t fix it because the source is still open.
- Visible granule loss or cracking at a roof detail above the kitchen. Age plus North Texas hail exposure. The shingle or membrane is at end of life, and patching a single spot will not hold.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included in Denton

For a kitchen remodel in Denton, the installed price range is $14,000 to $45,000. A smaller kitchen scoped to cabinetry and surfaces runs $9,000 to $20,000. Where the IKO-specified work is the driver, here’s how the line items break down:
| Scope | Installed range |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the range: whether the rough-in moves, cabinet box count and finish, countertop material (Cambria and Silestone run higher than a laminate), and whether the membrane and flashing work is exposed behind a wall or under a cabinet. You get a written price before work starts – always, non-negotiable. Every completed project carries the 365-Day Done Right Promise: if the work fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
An owner can safely do a few checks: read the label, measure the roll width, photograph the failed seam or flashing detail, and confirm whether the product is still under a manufacturer warranty. That’s it. The wrong DIY here is not a scratched cabinet handle – it’s re-flashing a detail above a kitchen bump-out while standing on a roof, or cutting into a wall cavity to chase a leak without knowing where the water is coming from. In Denton, we regularly see spring failures turn into rotted substrate and cabinet damage because a homeowner patched over a failed flashing instead of finding the source. Roof and flashing work at height carries real fall risk and should go to a trained professional. Our technicians have up to 22 years of experience, they’re background-checked and uniformed, and a live person answers the phone 24/7. Call (844) 651-3175 to schedule a free estimate – the written price comes before any tool does.
FAQs

Exposed flashing details typically hold 10 to 15 years in North Texas, and a properly installed waterproofing membrane under a cabinet can last the life of the kitchen – but hail exposure on anything above the roofline shortens that. Denton’s hail season is the main variable. Call (844) 651-3175 for an exact quote on your Denton kitchen – estimates are free.
Sometimes yes – a single lifted seam can be re-adhered if the membrane underneath is sound. A failed flashing detail above a bump-out usually needs replacement, not a patch, because the underlying substrate is already wet. We tell you which one you have before you commit to anything.
A flashing detail or membrane replacement on a kitchen bump-out is typically a one- to two-day job once materials are on site. A full kitchen remodel that includes the IKO-specified work runs several weeks depending on cabinetry and countertop lead times. You’ll get the schedule in writing.
We order to the model and lot code on your label from a supplier who carries the IKO line, and we confirm the spec against the label before installation. We don’t stock parts and we don’t carry parts on a truck – the right part is ordered for your job and documented on your spec sheet. Call (844) 651-3175 for a free estimate.
If you’ve got a failing IKO part in your Denton kitchen – or you’re planning a kitchen remodel and want the waterproofing and flashing done right the first time – call Bradford Remodeling Co Denton at (844) 651-3175 for a free estimate. We give you a written price before any work starts, a background-checked and uniformed crew on the job, and the 365-Day Done Right Promise in writing in your hand when we close the site clean.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












