







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ECO Window Systems Driveway & Pavers: The Denton Owner’s Guide
We install ECO Window Systems-compatible driveway and paver assemblies throughout Denton, and paver driveway work typically runs $7,000 – $18,000 installed, while a concrete driveway lands between $4,500 and $12,000. If you’re replacing a failed section rather than the whole run, driveway replacement in Denton usually comes in at $5,000 – $14,000. We’re an independent contractor and not affiliated with ECO Window Systems, so we match the spec to your actual system instead of guessing at a catalog number. Most Denton owners discover the problem the same way: a paver edge lifts after a freeze, water pools against the slab where it never used to, or a driveway apron settles and starts pulling away from the garage threshold.

Which ECO Window Systems Models This Applies To

ECO Window Systems builds to more than one series, and the driveway and paver interface hardware isn’t universal across them. The threshold transition, edge restraint, and apron detail change with the model line and with the elevation of the finished floor. Before we quote anything, we read the rating label on the unit itself, take field measurements at the sill and the apron, and confirm the paver base depth your slab was set to. That’s the compatibility gotcha: two Denton homes on the same street can have different base depths and different edge-restraint profiles, and a part that fits one will not seat on the other.
Then comes the OEM-versus-aftermarket question. For ECO Window Systems specifically, OEM edge restraint and threshold transitions give you a documented fit and keep the manufacturer’s compatibility intact. Quality aftermarket equivalents cost less and perform well for standard residential loading, but only where the base and drainage detail are right. We quote both paths in writing, with the spec for each, so you decide with a number in front of you rather than a shrug at the door.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ECO Window Systems Driveway & Pavers Is Failing
- Pavers lifting or rocking at the apron. Water is getting under the base and the bedding layer has washed out. North Texas clay swells and shrinks hard, and once that cycle starts, the paver never reseats on its own.
- Ponding at the threshold. The finish grade has dropped or the drain slope was set too flat. Standing water against the sill is the number one cause of the rot and settlement we find in Denton.
- Efflorescence or white chalky streaks. Moisture is moving through the pavers from underneath, usually a failed base or a missing edge restraint letting water in from the side.
- Separation between the drive and the garage slab. The transition detail has failed and the two surfaces are moving independently. Left alone, it widens every season.
- Sunken or cracked edge restraint. The restraint is what holds the whole field in compression. When it gives, the pavers spread and the pattern opens up.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work runs in Denton, installed, parts and labor together:
| Scope | Installed Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
The range moves on square footage, base depth, whether the old surface is removed and hauled, and how much grading the lot needs. You get a written, line-item price before any work starts, and it does not move at the door. Every completed project carries the 365-Day Done Right Promise: if the work fails within a full year, we come back and correct it at no charge. Belgard and Unilock hardscape products are part of our documented brand roster, so specs and manufacturer warranties are traceable.
DIY or Call Us?
You can safely check a few things. Look for water pooling at the threshold after rain, photograph the apron and any separation at the garage slab, and confirm the pavers rock underfoot. That’s diagnosis, not repair. Where DIY goes wrong on this work is the base and the drainage: a paver field is only as good as the compacted base beneath it, and re-laying the surface over a failed base guarantees the same failure next season. It also invites the injury risk of lifting and cutting heavy units without the right handling gear. Our technicians have up to 22 years of experience with substrate and grading in Denton’s soil, and they’ll tell you straight whether you need a repair or a replacement. Call (844) 651-3175 to schedule a free estimate.
FAQs

How long does a paver driveway last in Denton?
A properly based paver driveway lasts 25 to 30 years, but in Denton’s expansive clay soil the base and edge restraint are what fail first, often inside 10 to 15 years if drainage was set too flat. Sealing every two to three years helps. Call (844) 651-3175 for an exact quote – estimates are free.
Can this be repaired instead of replaced?
Often yes. A localized failed section, a bad edge restraint, or a sunken apron can be lifted, re-based, and reset, which usually costs far less than full replacement. The test is whether the base under the rest of the field is still sound. Call (844) 651-3175 and we’ll tell you which one you’re looking at.
How long does the swap take?
A section repair is typically a one- to two-day job, and a full paver driveway replacement in Denton generally runs three to five days depending on square footage and how much base work is needed. We give you the schedule in writing with the price. Call (844) 651-3175 to schedule your free estimate.
How do you source the part?
We source from documented manufacturers whose specs and warranties we can put in writing, including Belgard and Unilock for hardscape, and we confirm fit against your ECO Window Systems model before ordering. We don’t claim to carry parts on a truck – the right part is matched to your unit, not pulled off a shelf. We also work with KraftMaid, Cambria, and Silestone on other projects. Call (844) 651-3175 for a written quote.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












