







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Bathroom Remodeling: The Denton Owner’s Guide
Ameristar-compatible bathroom remodeling in Denton typically runs $9,000 – $28,000 installed, depending on whether you’re replacing a tub surround, a shower, or the full room down to the substrate. Smaller scopes land closer to $5,000 – $12,000. Most Ameristar bath products are replacement-part and enclosure systems, so we match the correct series, measure the rough opening, and install to the manufacturer’s spec rather than forcing a universal kit into the space. We’re an independent contractor, not affiliated with Ameristar.

Owners usually find the problem in one of three ways: a hairline crack spidering across a shower pan, a surround panel pulling away from the wall and letting water behind it, or a slow drip at a valve cartridge that started as a stain on the ceiling below. In Denton, the swing between humid summers and dry winters works seams and caulk lines harder than most of the country, and that’s usually where the failure starts.
Key Takeaways
- Ameristar bath remodeling in Denton: $9,000 – $28,000 installed; small baths $5,000 – $12,000.
- Match the exact Ameristar series before ordering parts; the rough opening and drain placement differ across lines.
- Every Bradford project gets a written price before work starts and the 365-Day Done Right Promise on the finished work.
- A live person answers our phone 24/7 at (844) 651-3175.
Which Ameristar Models This Applies To

Ameristar builds a range of bath products, and the part that fits one line won’t fit another. The two things that decide compatibility are the rough opening dimensions (the framed hole in the wall, measured stud to stud) and the drain location (center, left, or right). A pan that’s an inch off on the drain will not seat, and no amount of silicone fixes a misaligned drain.
Before we order anything, we ask for the model and serial plate. It’s usually a sticker on the back of a surround panel, inside a cabinet door on a vanity, or on the rim of a tub. If the sticker is gone, we measure: opening width, opening height, drain offset from each wall, and the valve centerline. That’s the documented scope The Garrison Standard requires, and it’s why our written price doesn’t move at the door.
On the OEM-versus-aftermarket question: for a shower pan or a surround panel, we recommend the manufacturer-specified part, because the panel profile and the pan lip are engineered to mate. For trim, valves, and drains, a documented name-brand equivalent (Kohler, Moen) is often the better long-term choice, and we’ll say so in writing. We also service KraftMaid, Cambria, and Silestone bath finishes, so if your remodel crosses into cabinetry or surface work, it stays under one written scope.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Ameristar Bathroom Remodeling Is Failing
- A crack in the shower pan or tub floor. Usually flex fatigue from a pan set on an uneven or under-supported subfloor. A crack lets water into the framing below, which is the expensive part.
- Surround panels pulling away from the wall. Water got behind the caulk joint and softened the substrate (the backer board behind the panel). Once the substrate is soft, re-caulking is a bandage, not a repair.
- Caulk lines that fail every season. Denton’s humidity swings expand and contract the joint. Repeated failure points to movement behind the wall, not bad caulk.
- A drip or stain on the ceiling below. That’s a valve cartridge or drain gasket leaking inside the wall. It reads as a plumbing fix but usually means opening the wall to inspect the substrate.
- Soft or spongy floor near the toilet or shower. Water has reached the subfloor. This is the one symptom we never treat as cosmetic, because the damage compounds quietly.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s how the Denton numbers break down for the scopes we see most often. These are installed ranges, parts and labor together, not a parts-only price:
| Scope | Installed range (Denton) |
|---|---|
| Full bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
What drives the range: whether the substrate is sound or has to be replaced, whether the drain and valve locations move, the finish tier you choose, and whether the project pulls a permit. We write the price before any work starts and put the scope in writing, so there are no numbers that move at the door. Every completed project carries the 365-Day Done Right Promise, a full-year written guarantee; if the work fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
You can safely check the model and serial plate, measure the rough opening, look for soft spots in the floor, and confirm where the leak is showing up. That information helps us quote accurately.
What we’d steer you away from: opening a wall to chase a leak, resetting a shower pan, or re-tiling over a wet substrate. Those aren’t hard because of the tools. They’re hard because the failure is usually behind the surface you can see, and covering it back up traps the moisture. Water damage in a Denton bathroom doesn’t announce itself; it shows up as a soft floor joist months later. If your pan is cracked or the substrate is soft, that’s the point to call. Reach us at (844) 651-3175 and a live person will pick up, day or night, to schedule a free estimate.
FAQs

A properly installed pan or surround typically holds up well for 15 – 25 years, but Denton’s humidity swings shorten that when the caulk joints and substrate aren’t maintained. The reality here is that the finish usually outlasts the substrate behind it, so a soft wall or floor is the real lifespan limit, not the panel itself. Call (844) 651-3175 for a free estimate if you’re seeing softness or a recurring leak.
Sometimes: a failed valve cartridge or drain gasket is a repair, and we’ll tell you so in writing rather than sell a full replacement. A cracked pan or a surround over a soft substrate is not a repair, because the damage is behind the surface. We quote the honest option, not the bigger one.
A shower replacement or surround swap is usually a multi-day project once the part is on site, and a full bath remodel runs longer depending on scope. We give you the timeline in the written quote before work starts, and we don’t promise same-day on planned remodel work, because nobody does that honestly. Call (844) 651-3175 to schedule your free estimate.
We identify your exact model from the plate or from measured dimensions, then order the manufacturer-specified part or a documented name-brand equivalent, and we tell you which and why in writing. We don’t carry parts on a truck; the correct part is ordered to your spec, which is why the written scope matters. Estimates are free at (844) 651-3175.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












