







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Home Additions & ADU: The Denton Owner’s Guide
We build Unilock-spec home additions and ADUs for Denton homeowners, and installed projects here typically run $45,000 – $130,000 for an addition and $90,000 – $220,000 for a detached ADU, with a written price before any work starts. This is planned construction, not an emergency call, so we schedule it properly rather than promise same-day work. Owners usually find out something is wrong at the worst moment: a sunroom wall that used to sit flush against the Unilock paver hardscape now shows a widening gap, the ADU slab edge has heaved after a wet Denton spring, or a frost line the builder tucked under a Unilock retaining course has started weeping water into the addition’s crawlspace. The Unilock product itself rarely fails. The interface between the structure and the hardscape behind it does.

Which Unilock Models This Applies To

Unilock doesn’t make home additions; it makes the hardscape products that wrap around them. That distinction matters when you’re diagnosing a problem, because what you’re matching is the Unilock paving or retaining system at the base of your addition or ADU, not a mechanical part on the structure. The most common Unilock lines in Denton settings are Brussels Block pavers in the patio and walkway, Cambridge Cobble in the driveway apron, and the structural retaining systems like Pisa2 or the pillar caps that hold grade back against a slab-on-grade addition.
To identify what you have, look for a stamped or labeled edge on the exposed course, measure face dimensions (Brussels Block reads about 200 mm by 100 mm face; Cambridge Cobble runs larger), and check the retaining block profile. For matching existing color lots, exact dye lots are not guaranteed forever, so on an older Unilock installation we plan for a slight tonal shift and tell you that up front rather than after the pallets land.
OEM vs. aftermarket here usually means Unilock-spec block versus a generic paver of similar size. A generic block that fits the dimension but not the joint spec will telegraph through the joint spacing and the water migration. We reference the Unilock product spec sheet for every interface detail and pair it with the structural side of the job. We’re an independent service provider and not affiliated with Unilock; we install and match their products to spec, and that’s all.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Home Additions & ADU Is Failing
- A gap opening between the addition wall and the Unilock paver course. Denton’s shrink-swell clay soil moves a lot between a wet spring and a dry August, and a paver apron that wasn’t set on a compacted, properly drained base shifts relative to the slab. The gap is the soil talking, not the block failing.
- Heaved or stepped pavers at the ADU slab edge. Water trapped against an ADU foundation with a shallow drain swells the clay underneath and lifts the pavers. If the edge steps more than about a quarter inch, it’s a drainage fix, not a cosmetic one.
- Rust staining or efflorescence on the Unilock face below the siding. Efflorescence is a white mineral bloom that means moisture is migrating through the paver or retaining unit behind the addition. Left alone, it points to water getting in where the hardscape meets the wall.
- Retaining block leaning or joints opening on a grade change. Unilock retaining systems have a build-in geogrid spec, and a course installed without the right grid in Denton clay will lean within a few seasons. The lean is the tell.
- Water pooling against the addition foundation after a storm. A paver apron or channel that no longer sheds water off the structure puts a large load of hydrostatic pressure on the foundation wall. That’s the failure that turns into a much bigger repair if you wait.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Replacement and rework pricing depends on scope, and we put the range on the page so you can see where you sit before anyone knocks:
- Home Addition (Unilock-matched hardscape + structure): $45,000 – $130,000 installed
- ADU Construction (with Unilock hardscape interface): $90,000 – $220,000 installed
- Garage Conversion: $30,000 – $80,000 installed
What moves the range: the size of the addition or ADU footprint, how much Unilock retaining or paving needs to be pulled and reset, foundation drainage corrections, and whether the job is engineered for Denton’s expansive soils. Every quote is written line-item and covers parts plus labor; there are no numbers that move at the door. Each completed project carries the 365-Day Done Right Promise: a full-year written guarantee, and if the work fails inside that window, we come back and correct it at no charge. When we close, you have a clean site, a documented scope, and the signed guarantee in your hand.
DIY or Call Us?
There’s a safe list of checks and a line you shouldn’t cross. You can safely measure the gap between the wall and the paver, photograph the stepped pavers, note where water pools after the next Denton rain, and read the Unilock product label on any exposed edge. Everything past that is structural. Pulling and resetting a paver base on an addition foundation means grading below a wall line, recompacting clay, and getting the drainage detail right, and doing it wrong on expansive Denton soil can drive water against the foundation instead of away from it. That’s not a weekend project worth risking. The Unilock face itself is rarely the problem; the base and drainage under it are. Call (844) 651-3175 and we’ll talk through what you’re seeing before you spend a dollar.
FAQs

How long does Unilock hardscape at a home addition actually last in Denton?
Unilock pavers and retaining systems, installed to spec on a properly compacted base, hold up for decades; the base and drainage under them are what fail first, and in Denton’s clay that usually shows up within 5 to 15 years. Call (844) 651-3175 for an exact quote; estimates are free.
Can this be repaired instead of a full addition rebuild?
Often yes. If the failure is a shifted paver course, efflorescence from a base drainage issue, or a leaning retaining course, we can pull and reset the Unilock section and correct the base without touching the structure. If the foundation wall has moved, the structural fix comes first. Call (844) 651-3175 and we’ll tell you which one you’re looking at.
How long does the work take?
A hardscape rework around an existing addition is typically a few days to a week; a new addition runs weeks to a couple of months and an ADU longer, depending on permitting and feet. You get the schedule in writing before tools come out. Call (844) 651-3175 for a free estimate.
How do you source the Unilock products and match my existing installation?
We reference the Unilock product spec sheet for the exact line and spec, order to that spec, and plan for color lot variation on older installations. We don’t claim to stock parts or carry them on a truck; we source to your specific spec. Call (844) 651-3175 to schedule your free estimate.
We also work with KraftMaid, Cambria, and Silestone on the interior side of additions and ADU projects, so the whole scope stays traceable to named manufacturer specs.
When you’re ready, call Bradford Remodeling Co Denton at (844) 651-3175 for a free estimate. A live person answers, day or night. You’ll get a written price before any work starts, background-checked technicians on the job, and the 365-Day Done Right Promise in writing. That’s The Garrison Standard in practice, and it’s how we run every Denton project.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












