







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Driveway & Pavers: The Denton Owner’s Guide
We install ActiveYards-compatible driveway and paver systems across Denton, and a full paver driveway installation here typically runs $7,000 – $18,000 installed, with most single-car and standard two-car drives landing in the $9,000 – $14,000 range. Driveway replacement sits at $5,000 – $14,000, and sealing an existing paver drive runs $250 – $700. Estimates are free and scheduled around your week, not ours.

Denton owners usually find the problem the same way: a section of pavers near the street apron has shifted, a joint line has opened up after a wet spring, or a corner paver near the garage door has rocked underfoot. What looked like one loose block almost always traces back to the base under it, and that’s the part that decides whether a fix holds. If you’ve already had someone reset the top layer once and it moved again, the substrate is the reason.
Bradford Remodeling Co Denton is an independent service provider and is not affiliated with ActiveYards. We work with the products directly and we’ll tell you plainly what your yard needs.
Key Takeaways
- Paver driveway installation in Denton runs $7,000 – $18,000; replacement runs $5,000 – $14,000.
- Most “failing pavers” in Denton are a base problem, not a paver problem.
- Every price is written before any work starts, and every completed project carries the 365-Day Done Right Promise.
- Call (844) 651-3175 and a live person answers, any hour.
Which ActiveYards Models This Applies To

ActiveYards is a manufacturer network, not a single product line, so the exact paver profile, thickness and color run on your drive depends on which authorized producer poured the units for your region. That matters for a repair, because matching a paver from a different producer’s run can leave you with a visible seam even when the dimensions line up on paper.
Here’s how to identify what you’ve got before anyone quotes you. Look for a stamp, engraving or ink mark on the side face of a paver you can lift, usually near the edge course or the apron where the bond pattern breaks. Photograph it. If there’s no mark, measure the unit: length, width and thickness to the nearest sixteenth of an inch. Standard driveway units in this market commonly run about 2 ⅜ inches thick, which is the number that tells you whether the system was built for vehicle loads or was really a patio unit pressed into driveway duty. That distinction, more than anything else, is what you’ll argue about with your installer later.
The OEM-versus-aftermarket call for ActiveYards is usually straightforward. For a spot repair of five pavers or fewer, a close-profile match from a reputable aftermarket producer is often the practical answer, and we’ll tell you when the color won’t be perfect so you can decide with your eyes open. For anything larger, or for a drive where the base itself is coming out, we source from the documented producer network so thickness and finish are traceable and the manufacturer’s own warranty paperwork travels with the material. We don’t carry stock and we don’t carry pavers on a truck. We source to your job and bring the paperwork.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ActiveYards Driveway & Pavers Is Failing
Each of these shows up in Denton drives for a specific reason. Knowing the cause saves you from paying twice.
- Paver sections rocking or tipping underfoot. The bedding sand under that unit has washed out or consolidated unevenly, usually after a heavy rain cycle. The paver itself is fine; the support under it isn’t.
- Sand joints eroding between units. Polymeric sand lifting out in sheets points to water moving through the drive rather than off it. That’s a drainage question on your lot, not a sand-quality question.
- Open joint lines running in a straight path across the drive. A straight-line open seam means the two sides of the drive are moving at different rates. On clay-heavy Denton soil, that’s the base expanding and contracting, and it will keep reopening until the subgrade is addressed.
- Corner pavers at the garage apron lifting or separating. This is the high-traffic, high-load point and the first place a too-thin base shows itself. Two-inch units set over an inadequate base lift at the corners before they crack anywhere else.
- Efflorescence – the white chalky haze – spreading after wet weather. Moisture is migrating up through the paving and evaporating on the surface. It can be surface-cleaned once, but if it returns each season, water is getting in from below.
One reality worth knowing: a properly built paver drive in North Texas will hold up through 20 years of summer heat cycling, but only if the base was compacted in lifts and the edge restraint was set into concrete, not spiked into loose soil. When we open a failing drive in Denton, the missing restraint is the culprit more often than the pavers are.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here are the numbers for Denton, installed, materials and labor together:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
What moves you within a range is square footage first, then the base work. Strip and haul, base depth and compaction, edge restraint set in concrete, and whether the existing subgrade is holding water all count. A drive with a failing base costs more than the same square footage over a clean one. We write the full price before a tool comes out, with the base scope itemized so you can see exactly what you’re paying for. No number moves at the door.
Every completed project carries the 365-Day Done Right Promise: a full-year written guarantee, and if the work fails inside that window we come back and correct it at no charge. You get that guarantee in writing, along with a clean site at close – swept, material hauled, and the signed paperwork in your hand.
DIY or Call Us?
You can safely handle the diagnosis yourself. Lift a couple of loose pavers at the worst spot with a flat bar, look at what’s under them, check whether the sand is even there and whether the base beneath is firm or soapy. Photograph the stamp. Measure thickness. Check your drainage by watching where water pools after rain. That inspection is free and it tells you a lot.
The base rebuild is where DIY goes wrong. Pulling up a drive and re-laying a compacted base in proper lifts takes plate compaction you can’t achieve by hand, plus edge restraint poured correctly and the right fall so water leaves the drive instead of sitting on it. Homeowners who reseat the top layer without addressing the base see the same failure inside a single season. There’s no serious injury risk here, just the real chance of paying for the same repair twice.
If you’d rather know the number than guess at it, call (844) 651-3175 and we’ll come out, look at the base, and put a written price in your hands. Estimates are free, and a live person answers at any hour.
FAQs

A properly built paver drive should hold 20 years or more in North Texas, provided the base was compacted in lifts and the edge restraint was set in concrete. The pavers themselves outlast the base in almost every failure we see; heat cycling and shrink-swell clay soil do more to your base than to the units.
Usually yes. If the failure is localized – a rocking apron section, one open seam, a spot where restraints failed – we can lift, rebuild the base under that area, reset the units and re-sand, and it typically stays well under the $5,000 – $14,000 full replacement range. When the movement runs the full length of the drive, replacement is the honest answer, and we’ll say so.
A spot repair is finished in a single day. A full driveway replacement in Denton typically takes three to six working days depending on square footage, base depth and weather, and we give you the schedule in writing before we start so you can plan around it.
We source from documented producers in the ActiveYards network so the thickness, finish and manufacturer warranty paperwork are traceable to your job. We don’t stock parts or carry pavers on a truck – we specify what your yard needs and bring it in for your install, with the specs on paper.
We also work with KraftMaid cabinetry, Cambria and Silestone surfaces, and the premium material roster behind every Bradford project.
Call (844) 651-3175 for a free estimate on your ActiveYards driveway or paver work in Denton. You’ll get a written price before any work starts, background-checked, uniformed technicians on the job, and work covered by the 365-Day Done Right Promise.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












