







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Home Additions & ADU: The Denton Owner’s Guide
We build and finish ES Windows-compatible home additions and ADUs in Denton, and typical installed pricing runs $45,000 – $130,000 for an addition and $90,000 – $220,000 for a detached or attached ADU, depending on square footage, foundation, and how far the MEP runs have to travel. Garage conversions sit lower, at $30,000 – $80,000. We quote these on a written scope before any work starts, not a ballpark at the door.

Owners of ES Windows units usually find their way to us because a window, door, or sliding unit in the new space has started to fail: fogged glass, a sash that won’t seat, water tracking on the interior sill after a Denton County downpour. The rest of the time it’s a rough opening that was framed to the wrong dimension and a unit that never fit right to begin with. In north Texas heat, those small failures show up fast once the space is conditioned.
Key Takeaways
- An addition in Denton starts at $45,000 and tops out near $130,000; a full ADU is $90,000 – $220,000.
- ES Windows compatibility is a rough-opening issue first, a product issue second.
- Permits and inspections are part of the written scope, not an add-on later.
- Every completed project carries our 365-Day Done Right Promise.
Which ES Windows Models This Applies To

ES Windows isn’t a single product line. It’s a family of vinyl and aluminum units, series-dependent, and the series determines your rough opening, frame depth, and nailing flange. That matters for an addition or ADU because the window schedule is set at framing, not after the drywall goes up. Get the rough opening wrong by a half inch and you’re either shimming a unit that will rack or reframing a wall that already has sheathing on it.
To identify what you have, start with the unit label. It’s usually on the top or side of the frame, visible when the sash is open, and it lists the series, nominal size, and glass package. If the label is gone, measure the visible glass and the frame opening both, then match against the ES Windows spec sheet for that series. The instinct most Denton homeowners have is to order the same nominal size and assume it’ll drop in. It often won’t.
On OEM versus aftermarket: for ES Windows, the glazing package and the sash balance are the two places aftermarket parts diverge most. A generic vinyl sash in a series-built frame can look right and still leak air at the corners within two summers. We source the manufacturer’s part when it’s available and tell you plainly when a quality aftermarket equivalent is the honest call. We are an independent contractor and not affiliated with ES Windows, so we have no reason to push one path over the other.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Home Additions & ADU Is Failing
These are the symptoms we see most often in Denton additions and ADUs, and what’s actually going on underneath.
- Fogging or condensation between the panes. The sealed glass unit has lost its desiccant seal, usually from heat cycling in an unconditioned or partly conditioned space. It’s a glazing failure, not a cleaning problem.
- Water stains on the interior sill or drywall directly below the window. Failing perimeter sealant or a missing sill pan under the flange. North Texas wind-driven rain finds that gap every spring.
- A sash that won’t latch or seal flat. The frame is racked, often because the rough opening was out of square and the unit was forced in. Common in additions finished by a different crew than the one that framed it.
- Drafts along the frame edge, especially at the corners. Air infiltration from an improperly shimmed or uninsulated perimeter. Shows up in January when the heat runs hard.
- A sliding door or large unit that drags or jumps the track. Roller wear or a settled header. In Denton’s expansive clay soils, a footer that moves will telegraph straight into the door frame.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For an ES Windows addition or ADU in Denton, the honest installed numbers break out like this.
| Scope | Installed Range |
|---|---|
| Home addition (framing to finish) | $45,000 – $130,000 |
| ADU construction (detached or attached) | $90,000 – $220,000 |
| Garage conversion to living space | $30,000 – $80,000 |
| Window replacement, whole home | $4,500 – $15,000 |
| Impact window installation | $8,000 – $25,000 |
What drives the range: square footage, foundation type (slab versus pier and beam, and Denton’s clay makes that a real conversation), how far plumbing and electrical have to run, and the window package itself. ES Windows units in a new addition are priced inside the scope, not billed as a surprise line.
You get a written line-item price before any work starts. No numbers that move once the crew is on site. Permits are pulled and inspections passed as part of the job. Every completed project is covered by our 365-Day Done Right Promise: if the work fails inside that window, we come back and correct it at no charge to you.
DIY or Call Us?
An owner can safely do a few things. Check for fogging between the panes, look for water staining on drywall below a window, run a hand along the frame edges in cold weather to feel for drafts, and open and close every sash and slider to see where it catches. Write down the unit label while you’re at it.
Where it goes wrong: replacing a sealed glass unit, reflashing a window flange, or resetting a sliding door in a settled header. A window or door set back into a wall without a proper sill pan and backer rod will look finished and leak within a season. Pulling glass from a unit and resealing it by hand rarely holds in Texas heat. And once you’re into framing, header, or footer work on an addition, that’s structural and permit territory, not a weekend job.
If your ES Windows unit is fogged, drafting, or leaking into a finished addition, call (844) 651-3175 and we’ll look at it. Estimates are free and the price we quote is written.
FAQs

Expect 15 to 25 years on the glazing seal and longer on the frame, though north Texas heat cycling shortens that on any unit in an unconditioned or partly conditioned space. Sealed glass is usually the first thing to go. Call (844) 651-3175 for a free look at yours.
Sometimes. A single fogged pane can be reglazed, and a sealant or flashing failure can often be corrected without touching the unit. A racked frame or a settled header usually means more than a repair. We’ll tell you which one you’re looking at before you spend anything. Call (844) 651-3175 for an exact quote.
A single window replacement is a day. A full window schedule inside an addition is folded into the build timeline, which runs weeks to months depending on scope. You’ll have the schedule in writing before work starts. Call (844) 651-3175 to talk through your project.
We match the label or measured opening to the ES Windows series spec, then order from the manufacturer where the part is available, or a quality equivalent where it isn’t. We don’t stock parts and we don’t carry them on a truck, so the match is confirmed before anything is ordered. Call (844) 651-3175 and we’ll start with your unit label.
We also install KraftMaid cabinetry, Cambria and Silestone surfaces, and finishes from a documented brand roster on the additions and ADUs we build across Denton. Every job gets a written price and the 365-Day Done Right Promise, and a live person answers the phone 24/7. Our technicians have up to 22 years of experience, and they’re background-checked and uniformed before they walk through your door. Call (844) 651-3175 for a free estimate.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












