







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Bathroom Remodeling: The Denton Owner’s Guide
If you own Oldcastle bath products in a Denton home, a full bathroom remodel using Oldcastle-compatible materials typically runs $9,000 to $28,000 installed, with a small bath in that family landing closer to $5,000 to $12,000. We install Oldcastle-compatible systems, pull the permits, and pass inspection, and your price is written down before any work starts. Oldcastle itself is a large building products maker whose bath lines reach you through distributors and big-box channels, and matching the right components to what’s in your bathroom is where most Denton remodels go sideways.

Owners usually discover a failure one of two ways. First, water shows up where it shouldn’t – a soft spot near the shower pan, grout that won’t stay sealed, or a ceiling stain in the room below. Second, an Oldcastle vanity top or tub surround that looked fine at purchase starts crazing, chipping at the edge, or flexing underfoot. Both are signs the substrate or seal beneath the finished layer has given out, not that the surface itself is defective.
Which Oldcastle Models This Applies To

Oldcastle bath products are sold under several brand families, and the exact line matters when we specify a replacement. Before we quote, we identify what you actually have by checking three things: the label on the back of the vanity top or tub surround (often a paper sticker or ink stamp on the underside), the rough opening dimensions of the tub or shower base, and the drain location (center, left, or right). Those three measurements tell us which Oldcastle-compatible base or surround will drop in without a substrate rebuild.
Here’s the compatibility gotcha that trips up Denton homeowners: Oldcastle tub and shower surrounds are manufactured to specific rough-in dimensions, and a surround spec’d for a 60-inch alcove won’t fit a 59-inch opening without trimming, which voids the manufacturer’s water-seal warranty. Measure the finished wall to finished wall, not the tub itself.
On the OEM-versus-aftermarket question: OEM Oldcastle replacement parts guarantee a dimensional match and keep the manufacturer’s warranty intact. A quality aftermarket equivalent (a names-brand vanity top or a Kohler or Moen fixture set) can cost less and perform as well, but it may require adapting the rough-in. We’ll show you both options in writing and let you decide. We work with the documented brand roster across the Garrison Standard, including Oldcastle-compatible components alongside KraftMaid cabinetry and Silestone surfaces where a Denton owner wants to upgrade while the wall is open.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Oldcastle Bathroom Remodeling Is Failing
- Soft or spongy floor near the tub or shower. This is water reaching the subfloor through a failed seal or pan membrane. The finished surface looks fine while the wood beneath is rotting, and the fix means replacing the substrate, not just re-caulking.
- Grout lines that crack within weeks of sealing. Repeated cracking means movement in the wall or floor behind the tile, usually from a loose backer board or a surround that wasn’t set on a flat substrate. Re-grouting buys a season at most.
- Crazing or hairline cracks in the vanity top or tub surround surface. Oldcastle’s cultured marble and composite surfaces craze when the substrate flexes or when they’ve been cleaned with the wrong product. Once the gel coat cracks, water gets behind it and the crack spreads.
- Water staining on the ceiling below the bathroom. A ceiling stain in the room underneath points to a failed drain seal or pan membrane, not a surface leak. This one needs diagnosis before it becomes mold in the joist bay.
- A shower base that flexes or rocks underfoot. A base set on an uneven or undersized mortar bed will flex, crack at the drain, and leak into the floor assembly. It’s the most common call we get in older Denton homes.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed pricing for an Oldcastle-compatible bathroom remodel in Denton runs $9,000 to $28,000 for a full bath, or $5,000 to $12,000 for a small bathroom remodel. A walk-in shower installation lands at $4,500 to $12,000; a tub-to-shower conversion at $3,500 to $10,000; a straight shower replacement at $3,000 to $8,500; and a vanity installation at $800 to $3,000. Those ranges hold across Denton.
What drives the number up: substrate repair (rot behind a failed pan adds real labor), moving the drain or supply lines, and going from a composite surround to tile on a backer board. What keeps it at the low end: a drop-in replacement that matches your existing rough-in exactly.
Every price we give is written before work starts, itemized by parts and labor, with no number that moves at the door. Permits are pulled and inspections passed. And every completed project carries the 365-Day Done Right Promise: if the work fails within a full year, we come back and correct it at no charge. Our technicians bring up to 22 years of experience to the job.
DIY or Call Us?
Some checks are safe for a homeowner. You can look for the Oldcastle label under the vanity top, measure your rough opening with a tape, and confirm the drain location. You can also check the caulk line at the tub edge and test the shower base for flex by standing on it. Those facts help us quote accurately over the phone.
Where DIY goes wrong: pulling a tub or shower base to replace a failed pan means cutting into the subfloor and the wall substrate, and a small error there sends water into the floor assembly for another season. Setting a new base requires a properly sloped mortar bed, and getting that wrong is how a “fixed” leak comes back. If you’re seeing a ceiling stain below, stop and call before you start opening walls. It’s honest work to know your limit here.
If you’ve got a failing Oldcastle surface and you’re in Denton, call (844) 651-3175 to schedule your free estimate. Estimates are free.
FAQs

Eight to fifteen years is realistic for Oldcastle cultured marble and composite surfaces in a Texas bathroom, and the seal and substrate underneath are what set that clock. Denton’s clay soils shift with seasonal moisture, and that movement is hard on tile and surround joints, which is why we see more grout cracking here than in stable-soil markets. Call (844) 651-3175 for an exact quote – estimates are free.
Sometimes, but only when the failure is at the seal and the substrate is dry. A rocking shower base or a ceiling stain below means the pan membrane or drain seal has already failed, and re-caulking won’t fix that. We’ll tell you straight in the estimate whether a repair holds or a replacement is the honest answer. Call (844) 651-3175 to schedule yours.
A straightforward drop-in replacement typically takes a few days; a full remodel with substrate repair and tile runs longer. The exact timeline lands in your written scope before work starts, so you’re not guessing. Call (844) 651-3175 for a free estimate.
We specify components against your rough-in dimensions and source them through the same distributor channels Oldcastle products come through, or offer a quality aftermarket equivalent that matches your opening. We don’t claim stock or carry parts on a truck – we order to your spec. Bradford Remodeling is an independent service provider and is not affiliated with Oldcastle. Call (844) 651-3175 for a written quote.
Your price is in writing, the work is permit-pulled and inspected, and the 365-Day Done Right Promise goes in your hand at job close – clean site, documented scope, signed guarantee. Call Bradford Remodeling Co Denton at (844) 651-3175 for your free estimate.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












