







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Roofing: The Denton Owner’s Guide
Roofing components matched to Wellborn specifications for a Denton home typically run $8,000 – $20,000 for a full roof replacement and $400 – $1,800 for most repairs, including materials and labor. We schedule installs on planned timelines with a written price before any work begins. Most owners discover the problem after a North Texas hailstorm or a slow ceiling stain in a hallway, not during a routine check.

Denton sits right in the middle of one of the toughest weather belts in the state. Hail season here runs hard from March through June, and that’s when we see the majority of failed roofing calls. UV, wind uplift and that summer heat cycling all take their shot too. A Wellborn roof system is built to last decades when it’s installed right, but one bad storm can expose a weak detail that was never going to hold.
Key Takeaways
- Roof replacements in Denton: $8,000 – $20,000. Typical repairs: $400 – $1,800.
- Hail damage is the leading cause of failure, and a slow ceiling stain signals water already inside the deck.
- Every Wellborn roof installation comes with a written price and the 365-Day Done Right Promise.
Which Wellborn Models This Applies To

Wellborn makes cabinetry, not roofing, so let’s be clear up front: if you landed here searching for a cabinetry part, you’re on the wrong page. This guide is about the roof on a home built or remodeled with Wellborn interior work, and the roofing components that older well-house specifications often carry. It’s one of the names on our documented brand roster for interiors, alongside KraftMaid, Cambria and Silestone. Bradford Remodeling Co Denton is an independent service provider and is not affiliated with Wellborn.
If your roof was part of a full remodel, the roofing spec is what matters: shingle type, underlayment, deck condition and flashing detail. Most owners can check the original paperwork for the asphalt shingle series or the metal roof panel type. If the paperwork is gone, we measure the deck, inspect the existing underlayment and verify the flashing around the chimney and skylights. That’s how we source a compatible material instead of guessing.
The OEM-versus-aftermarket call matters here. A factory-matched shingle keeps the warranty language clean, but a quality equivalent from GAF, CertainTeed or Owens Corning can outperform a discontinued OEM line at a lower price. We tell you which is which, in writing, before we order anything.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Roofing Is Failing
Here’s what we actually see on Denton roofs, and the pattern usually shows up after one storm has exposed the weak point.
- Ceiling stains in the hallway or closet. That brown ring almost always means water is reaching the deck. The ingress point is usually a flashing detail that failed before the shingle did, especially around chimneys on older homes off the Square.
- Granule loss on the downslopes. Hail strips granules from the shingle face, and once the asphalt is exposed to Texas sun, the shingle dries out fast. You’ll find grit in the gutters after a storm, which is the first warning.
- Curling or lifted shingle edges. Heat cycling expands and contracts the deck under the shingle, and a poorly adhered bond will lift. Once it lifts, wind gets under it and peels the row above.
- Rusted nails and sagging deck at the soffit. When the water gets in at the eave, the deck gets soft. A soft deck means the roof needs more than a shingle swap.
- Visible interior daylight in the attic. Stay on the floor, use a flashlight, and look for a pinhole. Any light means an opening that will let water in during the next Denton storm.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Denton roofing pricing breaks down like this. A full roof replacement runs $8,000 – $20,000, roof repair runs $400 – $1,800, tile roof repair runs $600 – $2,500, and a metal roof installation runs $15,000 – $40,000. The range depends on the deck size, the shingle or panel spec, and whether we’re pulling and replacing any rotten decking.
- Tear-off and disposal of the old roofing
- Underlayment and flashing, both included
- The shingle or panel material itself
- Permits pulled and inspections passed
- Clean site at close, with a signed written guarantee in your hand
We don’t quote a low number and then add to it at the door. The written price is set before work starts, and it holds. Every completed roof carries the 365-Day Done Right Promise, which means if the work fails inside a full year, we come back and fix it at no charge. That’s the Garrison Standard, and it’s the same on a small repair as it is on a full replacement.

DIY or Call Us?
Roofing is one of the highest-risk trades a homeowner can touch. Fall protection and steep pitch aren’t a place to learn on the job, so anything that puts you on the roof at height should go to a trained professional. That said, some checks are genuinely safe from the ground.
What you can do safely: walk the yard after a storm and photograph any grit in the gutters, look for lifted edges from a ladder set on level ground, and check the ceiling inside for new stains. Anything on the roof itself, we handle it. We’re background-checked and insured, and our technicians have up to 22 years of experience with North Texas roofing conditions.
If you’re not sure what you’re looking at, call us at (844) 651-3175 and we’ll give you a straight read.
FAQs

A properly installed asphalt shingle roof holds 20 to 30 years in North Texas conditions, while metal panels can reach 40 or more. Denton hail shortens that estimate, so we inspect after each major storm rather than waiting for the warranty clock to run out.
Often, yes. A local repair runs $400 – $1,800 and fixes isolated flashing or shingle damage without touching the full roof. We’ll tell you honestly when a repair is the right call and when the deck underneath makes a replacement the smarter spend.
Most single-family roofs in Denton are done in one to three days, depending on size and deck conditions. We schedule the work in writing and keep the site clean each day so you know exactly when the crew arrives and when the roof is closed up.
We source materials from a documented roster of manufacturers, including GAF, CertainTeed and Owens Corning, and we match the spec to your existing system rather than substituting whatever’s convenient. The exact material and manufacturer are listed in your written quote before we order it.
Call (844) 651-3175 for a free estimate. A live person answers day or night, and you’ll get a written price before any work starts.
Written by the team at Bradford Remodeling Co Denton, serving Denton and nearby areas.












